From "man xterm":
- Modes for setting keyboard style:
-
-
8-Bit Controls (8-bit-control)
- Enabled for VT220 emulation, this controls whether xterm will send 8-bit control sequences rather than using 7-bit (ASCII) controls, e.g., sending a byte in the range 128-159 rather than the escape character followed by a second byte. Xterm always interprets both 8-bit and 7-bit control sequences (see the document Xterm Control Sequences). This corresponds to the eightBitControl resource.
(Xterm Control Sequences is the document to which you linked earlier.)
But for some reason, the 8-bit control sequence I posted above isn't recognised by my xterm.
Ideally, it would recognise the sequences only between characters, but maybe it's detecting the sequences in the middle of characters too.
-
Are you posting in the right place? Check out Where do I post X? to know for sure.
-
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big>
<blockquote> <br /> <dd>
<dl> <dt> <em> <font>
<h1> <h2> <h3> <h4>
<h5> <h6> <hr /> <i>
<li> <nbsp> <ol> <p>
<small> <strike> <strong>
<sub> <sup> <table>
<td> <th> <tr> <tt>
<u> <ul>
-
Snippets of code should be wrapped in
<code> tags not
<pre> tags. In fact, <pre>
tags should generally be avoided. If they must
be used, extreme care should be
taken to ensure that their contents do not
have long lines (<70 chars), in order to prevent
horizontal scrolling (and possible janitor
intervention).
-
Want more info? How to link
or How to display code and escape characters
are good places to start.
|
