Ok so like I stated in my last post I have it working but for some reason I get it to get beyond the apply stage due to the fact that the next prompt looks the same. Below is a copy of the session when I do this manually:

>> Main- /cfg/slb/real 144/ena
Current status: disabled
New status: enabled

>> Real server 144 - apply
------------------------------------------------------------------
Apply complete; don't forget to "save" updated
configuration.

>> Real server 144 - save
Request will first copy the FLASH "active" config to "backup",
then overlay FLASH "active" with new config.
Confirm saving to FLASH y/n: y
New config successfully saved to FLASH.

>> Real server 144 - exit


So as you can see after the apply at the >> Real server 144 - prompt next I should/want to send "save" but expect get's stuck on the "apply" and wont move on to the next case match so it's almost like the thing goes into a never ending loop. Does anyone know of a way to force it to move on??

---

---

• Are you posting in the right place? Check out Where do I post X? to know for sure.
• Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:

  <code> <a> <b> <big> <blockquote> <br /> <dd> <dl> <dt> <em> <font> <h1> <h2> <h3> <h4> <h5> <h6> <hr /> <i> <li> <nbsp> <ol> <p> <small> <strike> <strong> <sub> <sup> <table> <td> <th> <tr> <tt> <u> <ul>

• Snippets of code should be wrapped in <code> tags not <pre> tags. In fact, <pre> tags should generally be avoided. If they must be used, extreme care should be taken to ensure that their contents do not have long lines (<70 chars), in order to prevent horizontal scrolling (and possible janitor intervention).
• Want more info? How to link or How to display code and escape characters are good places to start.