comment on

As I said, I don't have a usb printer, so I cannot test he theory. However, I belive that usb printers are basically serial printers eg. COMn:-like. I do know that you can redirect LPT1 to COMn:

P:\test>mode /status

Status for device LPT1:
-----------------------
    Printer output is not being rerouted.


Status for device COM1:
-----------------------
    Baud:            1200
    Parity:          None
    Data Bits:       7
    Stop Bits:       1
    Timeout:         OFF
    XON/XOFF:        OFF
    CTS handshaking: OFF
    DSR handshaking: OFF
    DSR sensitivity: OFF
    DTR circuit:     ON
    RTS circuit:     ON

P:\test>mode /status

Status for device LPT1:
-----------------------
    Printer output is being rerouted to serial port COM1


Status for device COM1:
-----------------------
    Baud:            1200
    Parity:          None
    Data Bits:       7
    Stop Bits:       1
    Timeout:         OFF
    XON/XOFF:        OFF
    CTS handshaking: OFF
    DSR handshaking: OFF
    DSR sensitivity: OFF
    DTR circuit:     ON
    RTS circuit:     ON
[download]

So, if usb are (or present themselves to the system as) serial ports, then it is entirely possible to re-route LPT1 to a usb printer.

The OP chose to set his usb printer to masquarade as LPT1 directly. Personally I would have chosen to have it set as a COM1:, then, should I ever attach a second printer to a serial port or another usb, I could set that to COM2: and chose which of the two my CLI apps wrote to by using the MODE command above.

I've had this set up on networked systems with half a dozen different local and network printers and it make life quite convenient.

Examine what is said, not who speaks.

"Efficiency is intelligent laziness." -David Dunham
"Think for yourself!" - Abigail
"Memory, processor, disk in that order on the hardware side. Algorithm, algorithm, algorithm on the code side." - tachyon

In reply to Re^5: Raw Data to Printer on Win XP by BrowserUk
in thread Raw Data to Printer on Win XP by dvergin

Are you posting in the right place? Check out Where do I post X? to know for sure.
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big> <blockquote> <br /> <dd> <dl> <dt> <em> <font> <h1> <h2> <h3> <h4> <h5> <h6> <hr /> <i> <li> <nbsp> <ol> <p> <small> <strike> <strong> <sub> <sup> <table> <td> <th> <tr> <tt> <u> <ul>
Snippets of code should be wrapped in <code> tags not <pre> tags. In fact, <pre> tags should generally be avoided. If they must be used, extreme care should be taken to ensure that their contents do not have long lines (<70 chars), in order to prevent horizontal scrolling (and possible janitor intervention).
Want more info? How to link or How to display code and escape characters are good places to start.


There's more than one way to do things
	PerlMonks