Don't feel bad, at first, I was thinking the same thing :)
Because I just reloaded all of my Pi devices from scratch, I'm unsure if this is an "issue" with the config of the serial device on-board or not quite yet. All I know is that after I built my PCB hard-soldered test platform with all my ICs and sensors I'm testing, but before the OS upgrade, it worked without hiccup.
No software changes to the serial code on my end (or my underlying C code), so I'm thinking it has to be how the device is configured hardware-wise.
-
Are you posting in the right place? Check out Where do I post X? to know for sure.
-
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big>
<blockquote> <br /> <dd>
<dl> <dt> <em> <font>
<h1> <h2> <h3> <h4>
<h5> <h6> <hr /> <i>
<li> <nbsp> <ol> <p>
<small> <strike> <strong>
<sub> <sup> <table>
<td> <th> <tr> <tt>
<u> <ul>
-
Snippets of code should be wrapped in
<code> tags not
<pre> tags. In fact, <pre>
tags should generally be avoided. If they must
be used, extreme care should be
taken to ensure that their contents do not
have long lines (<70 chars), in order to prevent
horizontal scrolling (and possible janitor
intervention).
-
Want more info? How to link
or How to display code and escape characters
are good places to start.
|
