I'm pretty sure all 20 worst nodes of the year is going to prove out of reach, at least I've never seen it done
I've been proved wrong! This rare feat has finally been achieved.
It lasted only for a few days though, towards the end of March 2018 (one example shown below).
This is a mind-bogglingly difficult feat to pull off, so much so that only
one monk in the entire history of Perl Monks has been able to do it, and even then only for a few days.
Though BrowserUk tried for a little while, he lacked the persistence, the staying power, week after week, month after month,
year after year, to keep on relentlessly posting the utter rubbish required to pull it off.
Worst Nodes of The Week
As of Mar 27, 2018 at 23:44 UTC, Next refresh in 1 hour and 15 mins ±15 min
Worst Nodes of The Month
As of Mar 27, 2018 at 12:21 UTC, Next refresh in 9 hours and 45 mins ±15 min
Worst Nodes of The Year
As of Mar 27, 2018 at 12:21 UTC, Next refresh in 9 hours and 45 mins ±15 min
-
Are you posting in the right place? Check out Where do I post X? to know for sure.
-
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big>
<blockquote> <br /> <dd>
<dl> <dt> <em> <font>
<h1> <h2> <h3> <h4>
<h5> <h6> <hr /> <i>
<li> <nbsp> <ol> <p>
<small> <strike> <strong>
<sub> <sup> <table>
<td> <th> <tr> <tt>
<u> <ul>
-
Snippets of code should be wrapped in
<code> tags not
<pre> tags. In fact, <pre>
tags should generally be avoided. If they must
be used, extreme care should be
taken to ensure that their contents do not
have long lines (<70 chars), in order to prevent
horizontal scrolling (and possible janitor
intervention).
-
Want more info? How to link
or How to display code and escape characters
are good places to start.
|
