I donīt know what to do with the comand that you post!
How can I reinstall TryCatcher in other directory?
When I try install it again through cpan I have the test failed:
# Failed test 'use TryCatch;'
# at t/catch_01.t line 6.
# Tried to use 'TryCatch'.
# Error: Can't locate Scope/Upper.pm in @INC (you may need to ins
+tall the Scope::Upper module) (@INC contains: /home/uce/.cpan/build/T
+ryCatch-1.003002-hybwUs/inc /home/uce/.cpan/build/TryCatch-1.003002-h
+ybwUs/blib/lib /home/uce/.cpan/build/TryCatch-1.003002-hybwUs/blib/ar
+ch /usr/local/lib/perl5/site_perl/5.24.0/x86_64-linux /usr/local/lib/
+perl5/site_perl/5.24.0 /usr/local/lib/perl5/5.24.0/x86_64-linux /usr/
+local/lib/perl5/5.24.0 .) at /home/uce/.cpan/build/TryCatch-1.003002-
+hybwUs/blib/lib/TryCatch.pm line 13.
# BEGIN failed--compilation aborted at /home/uce/.cpan/build/TryCatch-
+1.003002-hybwUs/blib/lib/TryCatch.pm line 13.
# Compilation failed in require at t/catch_01.t line 6.
# BEGIN failed--compilation aborted at t/catch_01.t line 6.
# Tests were run but no plan was declared and done_testing() was not s
+een.
# Looks like your test exited with 255 just after 1.
FAILED--Further testing stopped: Cannot load TryCatch
make: ** [test_dynamic] Erro 255
ASH/TryCatch-1.003002.tar.gz
one dependency not OK (Scope::Upper); additionally test harness failed
/usr/bin/make test -- NOT OK
//hint// to see the cpan-testers results for installing this module, t
+ry:
reports ASH/TryCatch-1.003002.tar.gz
Failed during this command:
VPIT/Scope-Upper-0.28.tar.gz : make NO
ASH/TryCatch-1.003002.tar.gz : make_test NO one depen
+dency not OK (Scope::Upper); additionally test harness failed
The Scope::Upper module is already installed too but in the directory ~/.cpan/build/Scope-Upper-0.28-DoTw6Z/lib
What should I do to make it in the right directory
-
Are you posting in the right place? Check out Where do I post X? to know for sure.
-
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big>
<blockquote> <br /> <dd>
<dl> <dt> <em> <font>
<h1> <h2> <h3> <h4>
<h5> <h6> <hr /> <i>
<li> <nbsp> <ol> <p>
<small> <strike> <strong>
<sub> <sup> <table>
<td> <th> <tr> <tt>
<u> <ul>
-
Snippets of code should be wrapped in
<code> tags not
<pre> tags. In fact, <pre>
tags should generally be avoided. If they must
be used, extreme care should be
taken to ensure that their contents do not
have long lines (<70 chars), in order to prevent
horizontal scrolling (and possible janitor
intervention).
-
Want more info? How to link
or How to display code and escape characters
are good places to start.
|