I've used OpenSCAD quite a bit for 3D design but I had forgotten that it will export to DXF. I don't know how I would write code in Perl to create OpenSCAD code. That would be an interesting project for a new module. I have about 6,000 drawings to create this way daily so it would need to be a general solution.
I have been planning to create SVG in Perl and then automate converting that to DXF with Inkscape. OpenSCAD might be even better at the SVG to DXF conversion. Thanks for the suggestion.
-
Are you posting in the right place? Check out Where do I post X? to know for sure.
-
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big>
<blockquote> <br /> <dd>
<dl> <dt> <em> <font>
<h1> <h2> <h3> <h4>
<h5> <h6> <hr /> <i>
<li> <nbsp> <ol> <p>
<small> <strike> <strong>
<sub> <sup> <table>
<td> <th> <tr> <tt>
<u> <ul>
-
Snippets of code should be wrapped in
<code> tags not
<pre> tags. In fact, <pre>
tags should generally be avoided. If they must
be used, extreme care should be
taken to ensure that their contents do not
have long lines (<70 chars), in order to prevent
horizontal scrolling (and possible janitor
intervention).
-
Want more info? How to link
or How to display code and escape characters
are good places to start.
|