Thanks.
I should have mentioned that module in my post. I will do the remote config (via telnet, IIRC) and then use TFTP. It does not have the serial port config section, though.
I was also unclear on how to enter a new configuration in the config file without downloading it from the router into the config file (with save). I have a library of configurations already and did not want to go to the trouble of loading each into a router then saving it into the config file of Cisco::Conf.
If you've used this module, maybe you can tell me how to do that?
Thanks! --traveler | [reply] [Watch: Dir/Any] [d/l] |